- The LED of the light source ensures a longer service life．
- The SPD of the detecting element ensures a higher response than conventional sensors.
- The light source is lit at a high frequency and is synchronized．There is almost no effect from peripheral light(less than 1/50，compared with a fluorescent lamp-type Autowide Sensor).
- The sensor gap be fixed at any position．
Principle of Operation
The right and left detectors detect the deviation of the strip edges from the center line, and send signals the amplifier. The amplifier amplifies the difference between the right and left signals and sends the signal to the hydraulic controller or electric controller to perform CPC.
When a strip travels with its center coincident to the center of the line, the signal from the amplifier is zero. In this state, the work cylinder is positioned at the center. When a strip deviates either to the right or to the left, the positive or negative signal, which is determined by the direction for correction, is transmitted to the controller, and the cylinder works in the direction to correct the displacement of the strip.
|Effective detecting length (mm)
|Strip width (mm)
|Power consumption (VA)
|Mass (1set) (kg)
|Sensor gap (mm)
||Type T : 300 - 1200mm ; Type M : 1200 - 3000mm
||SPD(silicon photo diode)
||LED(Light emitting diode)
|Effect of peripheral light
||100/110 V AC ±10% 50/60Hz
||0 - +50℃