Danh mục sản phẩm

Hỗ trợ trực tuyến

icon hotline


Hỗ trợ online

Icon điện thoại 0917.943.068

Icon email chien@tmpvietnam.com


Chi tiết sản phẩm

  • Bộ điều khiển canh chỉnh vị trí MGC1000 Nireco

  • Mã SP:
  • Giá : Liên hệ
  • Mã sản phẩm: MGC1000

    Xuất sứ: Japan

    Liên hệ tư vấn: 0917.943.068
    Email: chien@tmpvietnam.com

    Công Ty TNHH và DV Tăng Minh Phát là nhà phân phối chính thức của hãng NIRECO tại việt nam, chuyên cung cấp các thiết bị đo lường  hãng NIRECO tại Việt Nam, NIRECO Việt Nam


The Modular Strip Guide system controller MGC1000 is an EPC/CPC controller that can be connected by communications cables to the other devices in the system to enable a flexible system configuration.

  • The boards that comprise the controller are available as modules for each function. By connecting these modules via communications cables, you can configure the optimal system for your needs. This modular architecture enables boards to easily be changed in case of emergencies. It also allows the functions of the system to be easily upgraded as specifications change.
  • The system can be externally commanded to switch between control of a maximum of EPC 1 to 8, CPC 1 to 4, Cascade EPC 1 to 4, Cascade CPC 1 to 2.
  • The system can simultaneously actuate two hydraulic cylinders for CPC. (In-furnace CPC)
  • Control via P, I, PI, PD or PID controllers is possible.
  • The system can use either a nonlinear output in which deviations cause the output gain to change, or a speed gain output function in which the speed of the line changes the output gain.
  • By inputting the PLG signal, the staggered roll function and tracking output function can be used. (Can be used in combination)
  • The system can be externally commanded to shift the control position or the centering position. (The centering position cannot be changed (shifted) during cascade control.)
  • The sleeve alignment function can be used. (It cannot be used during cascade control.)
  • PROFIBUS and other Fieldbus interfaces are supported.
  • Input/output locations for the interface signals, including the analog signals and the Fieldbus communication signals, can be set by parameter input.
  • One controller can control up to four steerings.
  • Data logging can be performed. (Optional)
Power supply voltage DC24V
Power consumption Listed on each circuit board
Ambient temperature range 0 to +40°C
Ambient humidity range 35% to 85% RH or less (with no condensation)
Inputs and outputs From the specifications of the circuit boards (Options are shown inside the brackets.)
  • · Control boards: RS232C, RS422
    ( · Fieldbus circuit board: PROFIBUS)
    ( · PLG input board: open collector, voltage, line driver)
  • · Digital I/O board: photo-coupler inputs 16, contact outputs 16
  • · Control output / Position input board 1: control output, solenoid valve actuation output, position transmitter input, filter blockage warning contact input (1 input)
  • · Control output / Position input board 2: control output, position transmitter input
  • · Analog output board: voltage output 2
  • · Analog input/output board: input 1, output 1 (isolator input/output)
  • · CAN board: CAN port 1, RS232C port 1
  • · Analog sensor input board: sensor inputs 4, sensor alarm contact inputs 8

Sản phẩm cùng loại